I have been changing only Sensitivity, is this correct?įinally, I have on a couple of occasions spun the knob very quickly (to save a ball) and found my vaus going briefly in the oposite direction. Money Back Guarantee ensures YOU receive the item. Slube mentioned below Dial Digital Speed and Dial Sensitivity. Shop the Largest Selection, Click to See Search eBay faster with PicClick. Now, finally, it is there and works just perfectly. But I always hesitated because I wanted a standalone spinner (for reasons stated below), while basically all online instructions relate to integrating a spinner into your overall arcade control panel. Interested to know if this is comparable to anyone who has an arkanoid cab or believes there settings are correct.Īlso, I assume the mouse sensitivity in windows control panel has no affect? A spinner for MAME has always been in my plans simply because of Arkanoid. AY-3-8500 (Pong): now works with controls. NES: Arkanoid and Flying Hero now work with option Vaus. ![]() There are two basic variety of spinners, optical and analog. Spinner games dropped a bit in popularity in the early 1980s, but enjoyed a brief surge when Arkanoid was released (Arkanoid was probably the best spinner game ever made). NeoGeo: Pop’n’Bounce support works with correct dip switch paddle settings and arcade mode. The first spinner controllers were used in games like Pong, Breakout, and Super Breakout (and their many clones). If I catch the ball and then start the vaus from the left and turn my knob slowly, i go about half a turn until I hit the right hand side. Arkanoid: Works even better than before spinner resolution settings have an effect and the game is much more enjoyable. In any event, its clear that not every spinner is the same. ![]() Spinners (turn range not limited) use an optical encoder like Optiwiz, OptiPac, U-HID, or some of the KADE firmwares. Some folks claim it takes anywhere between 120-180 degree turn, while others say 60-90 degrees. I have been trying different sensitivity levels but either way I am not as good as I used to be on this game, and I expect this is not me getting older and slower!! Potentiometers (turn range is usually limited) need an analog encoder like a KADESTICK AVR (see link in sig), an A-Pac, or a U-HID. Have been using the TT2 with a customised knob just a bit smaller than the token top available from GGG. ![]() Old thread, but better to add my questions here than start a new one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |